+- Historic Shooting Forums (http://historicshooting.com)
+-- Forum: General (http://historicshooting.com/forum-1.html)
+--- Forum: The rifles (http://historicshooting.com/forum-2.html)
+---- Forum: Rimfire (http://historicshooting.com/forum-13.html)
+---- Thread: Hepburn project (/thread-2528.html)
Pages:
1
2
Hepburn project - Don McDowell - 04-10-2018
I ordered a barrel from McGowen, to have the 40-70 CSA Hepburn converted to a 22 bpcr rifle.
The plan is to send the barrel and rifle back to CSA and have Pat do the work on it.
Got notification today that McGowen shipped the barrel to me today.
RE: Hepburn project - Hiwall55 - 04-10-2018
That should be sweet.
Sounds like a great project.
RE: Hepburn project - Don McDowell - 04-10-2018
I really like the way the McGowen barrel on Carol's lowall shoots. I ordered this one with a 14 in twist. It's a round blank, Pat will contour it and install it, replace the breechblock with a rimfire block and extractor. The neat thing is , this will be the first 22 Hepburn they've turned out.
And maybe, with a bit of luck it'll be done in time to run it at the regional match in June.
RE: Hepburn project - Don McDowell - 04-12-2018
Woohoo, got the barrel from McGowen. Wanna see something silly looking, its an 1.25 round blank with that iddy biddy 22 hole down the middle of it.
Hopefully the weather is being nice tomorrow and I can get this mess packaged up and on the way to Pat.
RE: Hepburn project - Lumpy Grits - 04-13-2018
Did you have any ETA on return of the completed rifle?
Gary
RE: Hepburn project - Don McDowell - 04-13-2018
Pat mumbled something about 4-5 weeks.
RE: Hepburn project - Lumpy Grits - 04-13-2018
Not bad, for the work involved.
G.
RE: Hepburn project - Kurt - 04-13-2018
I have one of those silly looking 1 1/4" fence wire stretcher jack handles 
they can all laugh at that small hole they want. That stiff barrel just plain shoots [attachment=1105]
RE: Hepburn project - Kurt - 04-14-2018
Don have you decided yet what profile and length of this barrel?
That Hepburn in the want section sure is a looker.
RE: Hepburn project - Don McDowell - 04-14-2018
This blank is 28 inches, and will probably leave it at that.
Profile will be the same half round as the rifle wears now,,, unless I change direction and just have them build another rifle with this barrel on it, then may go with heavy taper octagon.