Dialing in a C Sharps 1885 45-70 BPCR

[Snocat]

Good morning it's great to see input and direction form you guys .I tend to wonder off course ....oh shinny !! Lol
Everything I've learned to this point has been from reading what everyone's posted over the years. Thanks !!!!
So thought it only fair that I add something even if its just a car wreck you can't help but look . Something to help with cabin fever . I've posted all the the results maybe it's helpful to someone.
I'm taking you guys all the way! Including the whipping I'm going to get at the Ridgeway Match ...with pics of course ! I'm determined not have the excuse my rifle and load were not up for the task .

This rifle and both molds 530 PJ and 510 Baco has been sitting in the safe for 4 yrs. My Shiloh has proven 560 Brooks is a great bullet.
Kurt your spot on with being more focused. My plan was to give all the new bullet molds a try with the same components then tinker futher with loads that show promise.
I'm starting to see wind affects these rifles a lot ! Compared to 338 and 408 hot rods pushed over 3k. And it's been breezey .lol

I cut out every paper group and scribble what it was and keep a file on that rifle .l find after a few days your mind forgets what it wanted to see and the paper shows what really happened.
I've got a few 400 yd groups that are not to shabby if you look at vertical it was brezzy.

Things on the to do list this weekend.
Taking lumpys advise and other top shooters.
Take my best four slip fit loads and full length resize with neck tension hopfully with bullet T.I.R. run out .002
Also tinker with Olde 2 and different primers , try to get E.S . Closer to Swiss .

If ya have a theory speak up ! I will put it on paper for ya!!

Sent from my XT1650 using Tapatalk