Historic Shooting Forums
Simple loading. - Printable Version

+- Historic Shooting Forums (http://historicshooting.com)
+-- Forum: General (http://historicshooting.com/forum-1.html)
+--- Forum: Reloading (http://historicshooting.com/forum-4.html)
+--- Thread: Simple loading. (/thread-271.html)



Simple loading. - Creeker - 12-14-2012

I needed 40 rounds of 30-06 for my friend so thought I’d take a few pictures.

Brass after sizing & running in the tumbler to remove the lube.
[Image: DSC04061.jpg]

Priming with CCI 200 on the RC.
[Image: DSC04060.jpg]
[Image: DSC04057.jpg]
[Image: DSC04058.jpg]

I took no pictures of the trimming, etc. Now for the charge.
[Image: DSC04062.jpg]
[Image: DSC04064.jpg]
[Image: DSC04067.jpg]
[Image: DSC04065.jpg]
[Image: DSC04071.jpg]

Seat the 150 grain Remington CL.
[Image: DSC04073.jpg]
[Image: DSC04074.jpg]
[Image: DSC04077.jpg]

Packaged & ready to go.
[Image: DSC04080.jpg]
[Image: DSC04081.jpg]



RE: Simple loading. - Don McDowell - 12-14-2012

Lynn , how do those loads shoot? I've never been around the data 85 powder. Looking at the data on the can it seems that load would work well in a garand?


RE: Simple loading. - Creeker - 12-14-2012

This is a rather slow powder Don. The label calls for 61.3 grains with a Hornady 150gr SST. I'm using the CL & the tech I called said to use 62 grains. Note the most IMR 4350 I've used with a 150gr. Jacketed is 60 grains.

A friend purchased an 8 pound jug from me & uses it in a Douglas barreled 1903 Remington with good results. His rifle is chambered in 6.5-06.

The load does 1 1/2" @ 100 in my Hogue stock 700 with a factory barrel. This CL isn't a target bullet. For my rifle I'll enclose a few pictures of the loads, data, & my settings.
[Image: DSC02896.jpg]

[Image: DSC02898.jpg]

[Image: DSC02900.jpg]

[Image: DSC02901.jpg]


RE: Simple loading. - Don McDowell - 12-15-2012

Thanks for the info Lynn, I'll have to watch for some of that powder. I have several rifles chambered in cartridges that do well with slow powders.


RE: Simple loading. - Kurt - 11-28-2013

Don,

Stay with the 4895 for the Garand and don't look back.
A powder to slow for the Garand will put it in full cycle. I grabbed the M-1 and a box of 06 rounds off the shelf without checking the loading data and loaded them in the clips. The rifle put a burst of 5 rounds down range. They were loaded for the bolt rifle with 4350. The slow powder sprung the op rod.


RE: Simple loading. - Crew Chief - 12-12-2013

IMR 4895 is a real good powder for the 30 calibers. I use it in my 308 to load for match grade ammo and hunting ammo. Sierra 168 BTHP love it.