Historic Shooting Forums › General › Reloading › Bullets and moulds v
PP mould for .45/70

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
PP mould for .45/70
12-07-2014, 01:45 PM,
#11
Ironramrod
Guest
 		 
RE: PP mould for .45/70
Don,

Yes, I would like to give a few of your 44-500P bullets a test drive; I'll be shooting them in a Shiloh .45/70. Looking at the bullet diagram on the Accurate website it looks like the diam. is 0.442. If I'm not exposing a trade secret, what are you using for patching paper w/ those bullets?

Regards
IR
Reply


Messages In This Thread
PP mould for .45/70 - by Ironramrod - 12-05-2014, 01:46 PM
RE: PP mould for .45/70 - by Kurt - 12-05-2014, 05:39 PM
RE: PP mould for .45/70 - by Don McDowell - 12-05-2014, 09:09 PM
RE: PP mould for .45/70 - by Ironramrod - 12-06-2014, 12:56 PM
RE: PP mould for .45/70 - by Kurt - 12-06-2014, 05:34 PM
RE: PP mould for .45/70 - by Ironramrod - 12-07-2014, 12:10 AM
RE: PP mould for .45/70 - by powderburner - 12-07-2014, 12:26 AM
RE: PP mould for .45/70 - by Ironramrod - 12-07-2014, 10:58 AM
RE: PP mould for .45/70 - by Don McDowell - 12-07-2014, 11:30 AM
RE: PP mould for .45/70 - by Kurt - 12-07-2014, 12:39 PM
RE: PP mould for .45/70 - by Ironramrod - 12-07-2014, 01:45 PM
RE: PP mould for .45/70 - by Don McDowell - 12-07-2014, 02:05 PM
RE: PP mould for .45/70 - by powderburner - 12-07-2014, 02:39 PM
RE: PP mould for .45/70 - by Ironramrod - 12-07-2014, 03:44 PM
RE: PP mould for .45/70 - by Ironramrod - 12-07-2014, 06:15 PM
RE: PP mould for .45/70 - by Ironramrod - 12-08-2014, 12:16 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication