Silhoutte Spec's

[Cody Smith]

Stock: Forearm must be attached and shall be of traditional design
not to exceed 2 inches in width, cannot extend below the line of the
bottom of the receiver or base of trigger guard, and no attachments
will be allowed on the forearm. Measured from the centerline of
the bore, the drop at the heel shall not exceed 2 3/4 inches; drop at
toe shall not exceed 8 inches. No portion of the rifle stock behind
the rifle action shall be higher than 3/4 inch below the centerline
of the bore. The butt shall not be longer than 5 1/4 inches top to
bottom. Cheek pieces are permitted, but no roll over. Pistol grips
are permissible, but no flared or hand-contoured styles. Crescentstyle
buttplates are permissible, but cannot be over 1 1/8 inch deep
when measured from a straight line from points of the buttplate.
Commercial recoil pads are permissible. Stocks and forearms must
be made of natural wood and must be in keeping with designs of
stocks of the era. (See Rule 3.18.)

More good stuff from the NRA rules book