Historic Shooting Forums › Trading Post › Wanted v
32-20 brass

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
32-20 brass
02-23-2015, 01:08 PM,
#5
powderburner Offline
Paper patch guru
****
 		Posts: 377
Location:
Joined: May 2012
Reputation: 2
RE: 32-20 brass
(02-23-2015, 09:02 AM)Nuclearcricket Wrote:
(02-22-2015, 04:11 PM)powderburner Wrote: just curious , can that be made out of 38 spl or 357 brass? just run it through a sizer?

No, the .38 cases are too large in diameter. The .32-20 case is .350 at the rim and the .38 cases are close to .375. Just too much to squeeze down.
Sam


thanks , I only looked at a case a time or two and always wondered , never had dies to try,so just kept thinking and not doing,
Dean Becker
only one gun but they are 74s
Find
Reply


Messages In This Thread
32-20 brass - by mherth - 02-22-2015, 03:15 PM
RE: 32-20 brass - by powderburner - 02-22-2015, 04:11 PM
RE: 32-20 brass - by Nuclearcricket - 02-23-2015, 09:02 AM
RE: 32-20 brass - by powderburner - 02-23-2015, 01:08 PM
RE: 32-20 brass - by Don McDowell - 02-22-2015, 04:42 PM
RE: 32-20 brass - by Don McDowell - 02-23-2015, 01:23 PM
RE: 32-20 brass - by Mike - 03-03-2015, 11:59 AM
RE: 32-20 brass - by mherth - 03-03-2015, 02:01 PM
RE: 32-20 brass - by Mike - 03-03-2015, 05:01 PM
RE: 32-20 brass - by John Boy - 11-26-2016, 02:29 PM
RE: 32-20 brass - by Don McDowell - 11-26-2016, 10:04 PM
RE: 32-20 brass - by Nuclearcricket - 12-01-2016, 11:18 AM
RE: 32-20 brass - by Don McDowell - 12-01-2016, 12:20 PM
RE: 32-20 brass - by Nuclearcricket - 12-02-2016, 09:46 AM
RE: 32-20 brass - by Don McDowell - 12-02-2016, 01:58 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication