Lead ?

[SgtDog0311]

Gunlaker, I'd be grateful for a 6 degree taper. I did two chamber casts... not realizing with the first one that it was a short chamber (2.080) so the leade ran right down to case mouth and obscured the transition. Cut the case back and did the second one. If there is any angle at all it does not show. The line didn't fill out exceptionally well since I was reluctant to pound on the bolt face after I first detected a bounce in the hammer/rod. But there does not seem to be any cone at all everything else bears that out.

I'll give posting pictures a try. Hope it works.
   
Sorry the picture is not clearer. The accompanying bullet is purposely oversized.
   
This one if it can be expanded shows the "exacto-knife-like-line" around the circumference.