Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
My way!
06-24-2015, 11:01 AM,
#10
RE: My way!
(06-24-2015, 09:23 AM)kokomokid Wrote: Dave, I will size after patching so a change in paper will give the same size. Die maker is guessing at what taper lead in and what width for the actual size contact.

Morning Kid-----------i use standard taper pin reamers----not certain the exact taper-----one thing that is important is to push the patched slug completely thru the parallel sizing section----i made that section about 3/4 inch long------make the pusher diameter right about 0.448/0.449 and tuck the patch well Big Grin

Keep the faith Sir

Dave
Ya ain't lost if ya don't care where ya are
Reply


Messages In This Thread
My way! - by Rick Mulhern - 06-22-2015, 01:08 PM
RE: My way! - by Dave Roelle - 06-22-2015, 02:21 PM
RE: My way! - by kokomokid - 06-22-2015, 03:34 PM
RE: My way! - by Dave Roelle - 06-22-2015, 03:57 PM
RE: My way! - by bruce moulds - 06-22-2015, 04:57 PM
RE: My way! - by Rick Mulhern - 06-22-2015, 05:16 PM
RE: My way! - by kokomokid - 06-22-2015, 07:55 PM
RE: My way! - by Dave Roelle - 06-23-2015, 09:32 AM
RE: My way! - by kokomokid - 06-24-2015, 09:23 AM
RE: My way! - by Dave Roelle - 06-24-2015, 11:01 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication