Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Jamison .45/110 brass
08-05-2015, 06:17 PM,
#15
RE: Jamison .45/110 brass
I know what you mean Dean. I've since sold my 45/110 to a good friend but my last loads were made using Norma brass trimmed back to fit the chamber. I was trimming to 2.886". There was not much to take off the Norma cases and they worked beautifully in the gun. Chambering rounds with brass at 2.865 is putting one 20 thou off and I would think best avoided if possible. Depending on I.R's chamber..I'd be guessing he could probably have his brass at a similar length of 2.880- 2.885 or so...but only he can determine this. My 44 happily takes cases to 2.270 but I wouldnt be recommending it as a start point for anyone.
Gavin.
" Don't know where I'm going but there's no sense being late " !
Reply


Messages In This Thread
Jamison .45/110 brass - by Ironramrod - 07-14-2015, 12:32 PM
RE: Jamison .45/110 brass - by Gunlaker - 07-14-2015, 01:07 PM
RE: Jamison .45/110 brass - by Ironramrod - 07-14-2015, 02:42 PM
RE: Jamison .45/110 brass - by rdnck - 07-14-2015, 03:24 PM
RE: Jamison .45/110 brass - by Don McDowell - 07-14-2015, 02:52 PM
RE: Jamison .45/110 brass - by Don McDowell - 07-14-2015, 02:54 PM
RE: Jamison .45/110 brass - by Ironramrod - 08-03-2015, 09:41 PM
RE: Jamison .45/110 brass - by powderburner - 08-04-2015, 10:00 AM
RE: Jamison .45/110 brass - by Ironramrod - 08-04-2015, 01:59 PM
RE: Jamison .45/110 brass - by powderburner - 08-04-2015, 04:10 PM
RE: Jamison .45/110 brass - by Don McDowell - 08-04-2015, 05:43 PM
RE: Jamison .45/110 brass - by Ironramrod - 08-04-2015, 08:23 PM
RE: Jamison .45/110 brass - by J.B. - 08-05-2015, 05:51 AM
RE: Jamison .45/110 brass - by powderburner - 08-05-2015, 10:14 AM
RE: Jamison .45/110 brass - by J.B. - 08-05-2015, 06:17 PM
RE: Jamison .45/110 brass - by Kurt - 08-11-2015, 05:26 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication