Bullet Molds

[Nuclearcricket]

Yes Kurt I fully agree. Till you purchase and then learn to use mastercam ( expensive software but very good), and then invest is a good quality cnc lathe, the tooling, and a nice mill to do the secondary work, the electricity and shop space for all of these fun toys you would still be way much farther ahead to patronize someone all ready in the business.
Now you don't need to use a lathe but it would make it easier. I say this because a while back I read a discussion on one of the sites and I honestly don't remember what one it was but it dealt with cast bullets. The guy had access during off hours to a high precision cnc milling machine and made some very very interesting bullet mold. He would cut them in brass and aluminum but was using end mills in the .010 diameter range. The bullets were very interesting, not very practical for the most part but definitely not something you run into every day.
Sam