Problem rifle

[Don McDowell]

Change the firing pin and load 50 rounds in Jamison brass, see if the groups hold then.Then pull the breechblock and make sure there's no primer/brass material building up in the firing pin hole/bushing.

Don,

I was hoping you would give me the secret pass word to get past Henry the Gremlin that keeps pushing the bullets out of line when I shoot.

I have so much brass for the 2.4 now that I could sell it for scrap and pay for the CPA
I did pull the pin and made sure no brass or crud was in the channel before I put it away last night. It was clean.
How are you getting along with your 2.4? don't hear you mention it.
I didn't want CPA to use their reamer after I looked at their print Gail sent me so I had one made. Might be a mistake but it will be my mistake if I made it wrong.

Haven't shot my 2.4 since the last 1000 yd target at Raton. And during that little affair, fired 8,9,10,10 in sighters 10,10,x in score, and then the wind went to pot and never got back on target. Other than that pretty darn good.
Fired back to back x's during the 1000 at Byers, but the guys pulling the target goofed around so darn long pulling and marking , we lost the mirage and the wind switched, but the score was still decent.