Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
In-line seating dies.......
09-16-2012, 08:39 AM,
#7
RE: In-line seating dies.......
I use the Redding Competition Seating dies. I am loading for different rifles, using different bullets and with the micrometer adjustment, it is just easier to reset bullet seating depth.

I use a 1" travel dial indicator on a magnetic base to put on top of the compression plugs to get that depth set (base goes on an empty spot on the Redding T7 plate, but a person could use a clamp on base) along with depth mics (probably a bit over the top).

By carefully measuring each component, I know what an overall cartridge length should be which allows you set the bullet exactly on top the wad with no deformation.
Reply


Messages In This Thread
In-line seating dies....... - by Lumpy Grits - 09-09-2012, 04:53 PM
RE: In-line seating dies....... - by .22-5-40 - 09-10-2012, 09:34 PM
RE: In-line seating dies....... - by Old Jim - 09-11-2012, 05:25 PM
RE: In-line seating dies....... - by Lumpy Grits - 09-13-2012, 11:54 AM
RE: In-line seating dies....... - by chaneylake - 09-13-2012, 09:11 PM
RE: In-line seating dies....... - by Lumpy Grits - 09-13-2012, 09:22 PM
RE: In-line seating dies....... - by drcook - 09-16-2012, 08:39 AM
RE: In-line seating dies....... - by Kurt - 09-16-2012, 11:00 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication