Accurate Molds 45-485XR

[Eric Johanen]

I think the key to this bullet is the height of the patch and the seating depth. I am getting no trace of lead with the patch being 22/32 high on the bullet. The 3/32 paper folded over the base is cut very clean. With the over all length set at 2.095 the paper patch clears the fouling at the chamber mouth and the rounds seat with just a hint of interference on the later chambered rounds. I thought I rolled one patch and when extracted it was fine with just some fouling on the front of the patch. I did change from .002 25% to 100% paper and the patch seemed tougher and with less possibility of stretching when I wet patch. With 2.100 brass there were no paper rings observed. I am liking this!