Historic Shooting Forums › General › Reloading › Paper Patch v
Patching the 32-40

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Patching the 32-40
11-30-2016, 06:21 AM,
#4
bruce moulds
Guest
 		 
RE: Patching the 32-40
don,
try this.
case droptubed full of 1f or 1.5f powder so wad is level with the top.
breech seat the bullets so there is a 1/16" gap between the base and the wad.
that gap might not be perfect, but will be close. don't be scared to experiment in small increments.
when the gap is right it will sing.
keep safe,
bruce.
Reply


Messages In This Thread
Patching the 32-40 - by Don McDowell - 11-29-2016, 06:07 PM
RE: Patching the 32-40 - by Gunlaker - 11-29-2016, 08:26 PM
RE: Patching the 32-40 - by Don McDowell - 11-29-2016, 08:28 PM
RE: Patching the 32-40 - by bruce moulds - 11-30-2016, 06:21 AM
RE: Patching the 32-40 - by Don McDowell - 11-30-2016, 10:34 AM
RE: Patching the 32-40 - by Gunlaker - 11-30-2016, 11:22 AM
RE: Patching the 32-40 - by Gunlaker - 11-30-2016, 11:25 AM
RE: Patching the 32-40 - by Don McDowell - 11-30-2016, 12:14 PM
RE: Patching the 32-40 - by Gunlaker - 11-30-2016, 12:58 PM
RE: Patching the 32-40 - by Don McDowell - 11-30-2016, 01:48 PM
RE: Patching the 32-40 - by bruce moulds - 11-30-2016, 04:03 PM
RE: Patching the 32-40 - by MIEagle - 10-02-2018, 07:40 AM
RE: Patching the 32-40 - by Flatlander - 10-03-2018, 02:09 PM
RE: Patching the 32-40 - by Flatlander - 10-04-2018, 02:38 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication