Historic Shooting Forums › General › Reloading › Blackpowder cartridge v
Getting most in 40-65 load

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Getting most in 40-65 load
10-17-2017, 10:15 AM, (This post was last modified: 10-17-2017, 10:15 AM by Rowdy Rick.)
#9
Rowdy Rick Offline
Member
***
 		Posts: 231
Location:
Joined: Oct 2012
Reputation: 1
RE: Getting most in 40-65 load
M2, yes even in some partially full length re-sized cases in my 2 7/8 I have ran into this on occasion. Careful wad sizing may be critical in these. Regarding my 40-65 I do not resize the cases, just fireform and shoot, not even annealed. This may help alleviate the problem you speak of . This is with a 350 gr PP bullet. Coincidentally this is one of my two most accurate guns.
Good discussion.

Rick
Find
Reply


Messages In This Thread
Getting most in 40-65 load - by Martini2 - 09-27-2017, 10:26 AM
RE: Getting most in 40-65 load - by Don McDowell - 09-27-2017, 11:40 AM
RE: Getting most in 40-65 load - by Martini2 - 09-27-2017, 06:20 PM
RE: Getting most in 40-65 load - by Martini2 - 09-27-2017, 07:25 PM
RE: Getting most in 40-65 load - by Hiwall55 - 09-27-2017, 01:15 PM
RE: Getting most in 40-65 load - by Martini2 - 10-15-2017, 02:50 PM
RE: Getting most in 40-65 load - by Kurt - 10-15-2017, 03:46 PM
RE: Getting most in 40-65 load - by Martini2 - 10-17-2017, 05:40 AM
RE: Getting most in 40-65 load - by Rowdy Rick - 10-17-2017, 10:15 AM
RE: Getting most in 40-65 load - by Martini2 - 10-18-2017, 05:43 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication