Hey Kurt

[Kurt]

TNX. Don but no dont split up your lot batch.

I have 300 Starline workable cases that are working good, but that stuff is so hard to swage down the base .005" I have to use the swage press to run them through the base swage die I made then I have to use a drift pin to drive them out or I will pull the rims off pulling them out of the die because they spring back .0014 and they have to be run through twice again before I anneal them for the second time for the first firing.

I ordered some Norma .45-120 sharps brass when there was a special on it and that is even harder to get the bases swagged down, so I will lay that brass back or the 45-2.4 PP loads if I need some.

What are you using 2 7/8 brass for?