Historic Shooting Forums › General › Reloading v
38/55 brass for a Ballard.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
38/55 brass for a Ballard.
02-18-2018, 12:23 AM,
#17
mikeg Offline
Junior Member
**
 		Posts: 17
Location:
Joined: Dec 2015
Reputation: 0
RE: 38/55 brass for a Ballard.
To add my 2 cents, have a couple of 38-55s, primary is a Stevens use crushed walnut shells in a vibrator for cleaning, run smokless and bp at the same speed and also run duplex, Swiss 1 1/2, IMR 4227, 4759 powder, 14" twist with a 310gr Hoch mould, Starline short brass. ringing steel plates 12" to 18" out to 500yrds, I'am happy.
Find
Reply


Messages In This Thread
38/55 brass for a Ballard. - by Ironramrod - 02-12-2018, 09:27 PM
RE: 38/55 brass for a Ballard. - by Don McDowell - 02-12-2018, 11:45 PM
RE: 38/55 brass for a Ballard. - by Ironramrod - 02-13-2018, 10:52 AM
RE: 38/55 brass for a Ballard. - by Don McDowell - 02-13-2018, 11:13 AM
RE: 38/55 brass for a Ballard. - by SgtDog0311 - 02-13-2018, 11:25 AM
RE: 38/55 brass for a Ballard. - by Kurt - 02-13-2018, 12:14 PM
RE: 38/55 brass for a Ballard. - by Ironramrod - 02-13-2018, 12:56 PM
RE: 38/55 brass for a Ballard. - by SgtDog0311 - 02-13-2018, 04:59 PM
RE: 38/55 brass for a Ballard. - by SgtDog0311 - 02-13-2018, 05:09 PM
RE: 38/55 brass for a Ballard. - by Ironramrod - 02-15-2018, 05:44 PM
RE: 38/55 brass for a Ballard. - by Don McDowell - 02-15-2018, 05:52 PM
RE: 38/55 brass for a Ballard. - by Ironramrod - 02-15-2018, 09:08 PM
RE: 38/55 brass for a Ballard. - by Hiwall55 - 02-15-2018, 09:57 PM
RE: 38/55 brass for a Ballard. - by Ironramrod - 02-16-2018, 02:28 PM
RE: 38/55 brass for a Ballard. - by mikeg - 02-18-2018, 12:23 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication