Historic Shooting Forums › General › The front porch v
cast bullet weight tolerance question

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
cast bullet weight tolerance question
12-31-2012, 03:37 PM,
#11
Lumpy Grits Offline
Trouble on the hoof
*****
 		Posts: 1,501
Location: Springfield, Missouri-U.S.A. Earth
Joined: May 2012
Reputation: 0
RE: cast bullet weight tolerance question
(12-27-2012, 06:24 PM)Old Jim Wrote: My certified 20:1 alloy casts bullets within a grain spread in the 0.458. It seams the best temp. has to be around 780* for good, filled-out, consistant wt. bullets.

YMMV

So does my 30:1.
I never keep the first 5-6 bullets even after preheating the mould.
Gary

Hav'n you along, is like losing two good men.....
Find
Reply


Messages In This Thread
cast bullet weight tolerance question - by chaneylake - 12-26-2012, 07:25 PM
RE: cast bullet weight tolerance question - by chaneylake - 12-26-2012, 08:36 PM
RE: cast bullet weight tolerance question - by chaneylake - 12-26-2012, 11:59 PM
RE: cast bullet weight tolerance question - by chaneylake - 12-27-2012, 02:14 PM
RE: cast bullet weight tolerance question - by chaneylake - 12-27-2012, 06:00 PM
RE: cast bullet weight tolerance question - by Lumpy Grits - 12-31-2012, 03:37 PM
RE: cast bullet weight tolerance question - by Smokin Guns John - 01-05-2013, 05:31 PM
RE: cast bullet weight tolerance question - by chaneylake - 01-06-2013, 04:45 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication