First chamber cast

[Kurt]

Arnie.
All of your posts on the DDEPP bullets has me interested. I have a BACO .40 caliber mould that is to small in diameter and at almost 1.490" long I think I will put the fly cutter in the mill and shorten that cavity up to 1.325" and put the boring bar in and open it to your .405 base. I haven't used that mould since BA has been making moulds. This is one of the first two pin moulds they made. Dave called me when they were gearing up for making moulds and asked me what I would want in a .40 caliber PP cavity. But I had it made to long and not wide enough because I wanted it for a hunting bullet so I can shoot without fouling control.
I think this will be a good project learning how to use this new mill.