It's been quiet here

[Kurt]

So I will make a little chatter
I been spending time learning how to use my new mill so I had a BA mould I ordered undersized at .428 to shoot dirty with in my .44-77. It's the BA Jim-428/490. With all the latest interest in Arnies DDEPP bullet designs I thought , well it is a good time to work on moulds.
I put the boring bar chuck in the mill and opened the base to .444" this added 6 gr of weight to the bullet and it's a snug fit for the fired .44-77 Farmers fired vase but it's perfect.
I put the scope back on the .44-77 Farmer with the 17 ROT and I got the scope zeroed and took 10 shots with the bullet I modified. And I think it will work.
I used a unsized fired case primed with a Fed GM match primer.
78 gr of the new lot of 1.5 Swiss.
The bullet is the modified Jim 428/490
This bullet gained 6 gr cutting that base.