Historic Shooting Forums › General › Reloading › Bullets and moulds v
New trick?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
New trick?
04-22-2022, 05:41 AM,
#8
Randy Bohannon Offline
Member
***
 		Posts: 180
Location: Buffalo Wyoming
Joined: Mar 2017
Reputation: 0
RE: New trick?
You can flux the tin right out your melt over doing it at high temps 750 or higher,tin is lighter and will come to the surface at high temp mixes in the dross and gets skimmed off. A little junk floating on the top isn’t a problem if you stir well and dip from the bottom of the furnace.
Find
Reply


Messages In This Thread
New trick? - by Don McDowell - 02-08-2020, 03:42 PM
RE: New trick? - by Old Jim - 02-08-2020, 06:25 PM
RE: New trick? - by Don McDowell - 02-08-2020, 06:34 PM
RE: New trick? - by Kurt - 02-08-2020, 08:39 PM
RE: New trick? - by Don McDowell - 02-08-2020, 10:29 PM
RE: New trick? - by Lumpy Grits - 02-10-2020, 09:34 PM
RE: New trick? - by kenny s - 04-21-2022, 11:34 AM
RE: New trick? - by Randy Bohannon - 04-22-2022, 05:41 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication