Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wads
03-04-2013, 10:04 PM,
#9
RE: Wads
The wad stack I use for a PP match load consists of a .023 OJ wad over the powder a .025 lube wad then a .060 cork and a .012 poster board under the bullet.
This wad stack does the best job sealing the gas from getting by the bullet before the bullet has a chance to bump up and seal the bore. I get the lowest ES and SD using this wad combination and I think that the cork is what is holding the consistent spread because it seals as soon as the pressure builds up on ignition by expanding before the lead bullet does.
A wad does more then protect the bullet base. It also acts like piston rings in a engine and also helps scrape fouling with the use of a good lube.

For the GG bullet that is already at or above groove diameter a OJ wad with a paper wad under the bullet is enough.

Kurt
The reason a dog has so many friends is because he wags his tail instead of his tongue.
Reply


Messages In This Thread
Wads - by Don McDowell - 03-04-2013, 12:00 PM
RE: Wads - by Don McDowell - 03-04-2013, 02:07 PM
RE: Wads - by Kurt - 03-04-2013, 04:13 PM
RE: Wads - by Don McDowell - 03-04-2013, 04:28 PM
RE: Wads - by Kurt - 03-04-2013, 04:41 PM
RE: Wads - by Brownie Nash - 03-04-2013, 07:20 PM
RE: Wads - by Brownie Nash - 03-04-2013, 07:25 PM
RE: Wads - by Don McDowell - 03-04-2013, 07:36 PM
RE: Wads - by Kurt - 03-04-2013, 10:04 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication