Historic Shooting Forums › General › Reloading › Bullets and moulds v
Salvaging -purifying mixed alloys ?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Salvaging -purifying mixed alloys ?
11-11-2013, 12:54 AM,
#13
Shadow 4
Guest
 		 
RE: Salvaging -purifying mixed alloys ?
(11-10-2013, 08:50 PM)Dan Cash Wrote: High velocity smokeless paper patch bullets for target work don't seem to care what they are cast of as long as the mould fills out.

Good lord, & I thought I spoke blasphemy at times, yikesExclamationExclamationExclamationExclamationExclamation

Lookout folks this is gonna get westernBig Grin

Think I'll set on the sidelines for this oneTongue
Reply


Messages In This Thread
Salvaging -purifying mixed alloys ? - by J.B. - 09-01-2013, 10:00 PM
RE: Salvaging -purifying mixed alloys ? - by J.B. - 09-01-2013, 10:57 PM
RE: Salvaging -purifying mixed alloys ? - by Kurt - 09-02-2013, 10:45 AM
RE: Salvaging -purifying mixed alloys ? - by Kurt - 09-02-2013, 06:28 PM
RE: Salvaging -purifying mixed alloys ? - by john olsen - 11-08-2013, 01:24 AM
RE: Salvaging -purifying mixed alloys ? - by john olsen - 11-08-2013, 01:28 AM
RE: Salvaging -purifying mixed alloys ? - by Kurt - 11-08-2013, 10:31 AM
RE: Salvaging -purifying mixed alloys ? - by Shadow 4 - 11-11-2013, 12:54 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication