Historic Shooting Forums › General › The front porch v
How is the chamber lead angle determined?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
How is the chamber lead angle determined?
03-04-2014, 12:00 AM, (This post was last modified: 03-04-2014, 12:51 AM by Kurt.)
#32
Kurt Offline
Grand advisory committee
*****
 		Posts: 4,246
Location:
Joined: May 2012
Reputation: 2
RE: How is the chamber lead angle determined?
Todd my reamer wont clean up your chamber end it is about .360" in my case neck and it will leave a ring just about where the base of the PP bullet will be. This reamer was made so I could use a GG bullet and the fired brass comes out of the chamber at .467" it will just except a .446 GG.
[Image: pad3001544-90BN.jpg]
The reason a dog has so many friends is because he wags his tail instead of his tongue.
Find
Reply


Messages In This Thread
RE: How is the chamber lead angle determined? - by Iron Coyote - 03-02-2014, 11:46 PM
RE: How is the chamber lead angle determined? - by Iron Coyote - 03-03-2014, 05:56 PM
RE: How is the chamber lead angle determined? - by Kurt - 03-04-2014, 12:00 AM
RE: How is the chamber lead angle determined? - by Gunlaker - 03-06-2014, 12:28 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication