Smith Enterprise Rear Sight

[Klaus]

Klaus,

I have a Smith XLR buckhorn sight on an old 45/90 roller, works very well. Got it about 10+ years ago, but I don't think they have changed the design. They offer two models, 3/8" dovetail and 0.450". The long-range, upright portion of the sight has small indents along the side so the shooter can mark the indent groove for the 200, 300 yd. distances. With the LR sight folded down, my sight is dead-on at 100 yds. My front-sight is a copper blade.


Best of luck,

Jim

Hello Jim

thx a lot for your reply
thats what i am looking for but i was afraid to waste my money if it would fail. So i was asking here for some advises.
Unfortunately this sight was not available here in Germany
From where do you have got yours ?
I found Brownells and Midway as dealer in the US.

thx Klaus