We Shot the Sausage

[Dave Roelle]

Morning Sam:

These are the tools i use in "hollow pointing" creedmore PP bullets.









I made the holding fixture at the shop, bored in the lather to a 0.0005 interference fit to the bullet

I do the hollow pointing in my workshop at the house, its a bit of "fiddling" to get on center but when ya got it ya got it-----save a 30 minute trip to the shop to use a mill

I use the 3/8 center cutting end mill to create the meplat then switch to a drill ----use lots of oil lead pushes ahead of the tool easy and gets sticky if you don't.

hope this helps Sam---have a great day

Hi Klaus:

Hows this one ?





There are bigger pigs on the place, my black gun buddy dumped this one




I've collected hogs up to 400 pounds----none that big recently, the one Craig shot with the AR was 63 inches long nose to nuts

I spent some time over the years in Cologne-----used to go to the S.P.O.G.A. show ----stayed on the river across from the cathedral----nice city for sure

A little damage meat is the price payed for good bullet performance----shootem in the right place and its not a problem

Keep well and stay safe

Dave

Dave