Girly Gun

[Kurt]

Steve.
I just finished blowing out 300 new cases using spilled and mixed powder and odd and end mixed primers I use for this kind of job. I had to order a new mould because I got the horse hooked behind the beer wagon ordering a mould before I had the rifle and it turned out the bore is very tight and a .395 bullet is way to tight. It takes two thumbs to get it seated close enough so the breach block can finish caming it in. I know this compresses the powder more and most likely squeezes the lube past the bullet so I ordered a new mould from Brooks. The rifle is in the rack till I get the new mould. But I have to say even with junk loads I have seen very tight clusters of holes on the 200 yard paper and also basketball groups.
I should have the mould in two weeks then serious loads will go through it.
Kurt