Historic Shooting Forums › General › Reloading › Paper Patch v
Development of PP loads for the .44-77.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Development of PP loads for the .44-77.
06-30-2020, 08:04 PM,
#101
Distant Thunder Offline
Posting Freak
*****
 		Posts: 921
Location: NE Wiscinsin
Joined: May 2017
Reputation: 0
RE: Development of PP loads for the .44-77.
Hiwall55,

I checked the bore of my Krieger barrel today and a .4378" gage pin fit very close and pushed through as smooth as silk. I would say it is very close to .4380-.4382". I'm very happy with the barrel compared to my Green Mountain .44 caliber which has a .436" bore diameter. When I asked GM about that I was told that their ".44 caliber barrels run on the tight side".
Jim Kluskens
aka Distant Thunder
Find
Reply


Messages In This Thread
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 09:24 AM
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 05:59 PM
RE: Development of PP loads for the .44-77. - by Distant Thunder - 06-30-2020, 08:04 PM
RE: Development of PP loads for the .44-77. - by seahawk - 07-01-2020, 10:08 AM
RE: Development of PP loads for the .44-77. - by Steveu - 07-31-2020, 11:16 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication