Historic Shooting Forums › General › Reloading › Paper Patch v
Development of PP loads for the .44-77.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Development of PP loads for the .44-77.
07-01-2020, 03:12 PM,
#106
Kurt Offline
Grand advisory committee
*****
 		Posts: 4,247
Location:
Joined: May 2012
Reputation: 2
RE: Development of PP loads for the .44-77.
Well Jim, when you have new cases for a straight walled chamber what are you firefobming? nothing.
When you take a straight walled basic case and run it through a die swaging a shoulder on that straight walled case that goes not get the transition taper p[roperly then you are firefobming the case blowing out the shoulders of the bottle necked case. Smile
Than when this has been done then the load development starts.
With new straight walled that are like a resized case when you get them new chances are they will shoot very accurately and your not forming anything Smile
The reason a dog has so many friends is because he wags his tail instead of his tongue.
Find
Reply


Messages In This Thread
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 09:24 AM
RE: Development of PP loads for the .44-77. - by Gunlaker - 06-29-2020, 05:59 PM
RE: Development of PP loads for the .44-77. - by seahawk - 07-01-2020, 10:08 AM
RE: Development of PP loads for the .44-77. - by Kurt - 07-01-2020, 03:12 PM
RE: Development of PP loads for the .44-77. - by Steveu - 07-31-2020, 11:16 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication