Development of PP loads for the .44-77.

[beltfed]

HI, Jim,
Sorry I did not get back to you earlier today. We went "to town" to get some
needed shopping done.
I like your design/dimensions. I am sure that you have set the diameters
according to your now in-hand rifle. And the base band length to fit that slight freebore
plus .100-.125 in the case. Good Nose /body percent of length at 56.6 to 43.4 % of total length
Only thing I might change would be to drop the base of ogive diameter another 0.001 so it would
be easier to see when patching.
Hope that Dave approves of cutting the mold.

And, Kurt, I hope they cut your 44 mold, too.

Regards.
Again, this is exciting.
Arnie