Historic Shooting Forums › General › Reloading › Bullets and moulds v
Accurate Molds

Thread Rating:
  • 1 Vote(s) - 1 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Thread Modes
Accurate Molds
04-03-2013, 10:14 AM, (This post was last modified: 04-03-2013, 10:15 AM by Mike.)
#2
Mike Offline
Posting Freak
*****
 		Posts: 1,014
Location: Wet Washington
Joined: Oct 2012
Reputation: 2
RE: Accurate Molds
I just got my new #44-400P from Accurate. It is a tapered bullet, going from .432" at the front to .437" at the base. Those figures are for wheelweight metal and with softer lead one bullet that I measured was .430" near the front and .435" at the base, weighing 402 grains. When patched with the 9 pound paper from BACO they slide snuggly into the case with the neck expanded in C&H dies. No shots have been fired as yet but I'm sure ready to!
Find
Reply


Messages In This Thread
Accurate Molds - by Caprock - 03-04-2013, 11:09 AM
RE: Accurate Molds - by Mike - 04-03-2013, 10:14 AM
RE: Accurate Molds - by Don McDowell - 04-03-2013, 10:31 AM
RE: Accurate Molds - by Mike - 04-03-2013, 10:45 AM
RE: Accurate Molds - by Mike - 04-03-2013, 11:37 AM
RE: Accurate Molds - by Don McDowell - 04-03-2013, 11:01 PM
RE: Accurate Molds - by Kurt - 04-03-2013, 11:34 PM
RE: Accurate Molds - by Mike - 04-03-2013, 11:38 PM
RE: Accurate Molds - by Don McDowell - 04-04-2013, 12:03 AM
RE: Accurate Molds - by Mike - 04-04-2013, 09:57 AM
RE: Accurate Molds - by Don McDowell - 04-04-2013, 10:08 AM
RE: Accurate Molds - by Mike - 04-04-2013, 10:27 AM
RE: Accurate Molds - by Don McDowell - 04-04-2013, 10:49 AM
RE: Accurate Molds - by Kurt - 04-04-2013, 11:23 AM
RE: Accurate Molds - by Don McDowell - 04-04-2013, 11:54 AM
RE: Accurate Molds - by Kurt - 04-04-2013, 12:10 PM
RE: Accurate Molds - by Mike - 04-06-2013, 08:58 PM
RE: Accurate Molds - by Don McDowell - 04-06-2013, 11:24 PM
RE: Accurate Molds - by Ironramrod - 08-09-2013, 09:46 AM
RE: Accurate Molds - by Kurt - 08-09-2013, 10:46 AM
RE: Accurate Molds - by Don McDowell - 08-09-2013, 10:56 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)

Contact Us | HistoricShooting.com | Return to Top | | Lite (Archive) Mode | RSS Syndication